15353 Autoloader ALE: STEP : axis 1 not initialized Trendsetter_400/800_Proofing This error should not occur during normal machine operation. If it does, first select the RESUME button from the workstation dialog box. If that does not correct it, select RESET TRENDSETTER from the workstation TRENDSETTER pull-down menu. If the problem persists, call Creo Service. Type "vr init" or "ale init" at the diagnostic monitor prompt. If that does not correct the problem, check the TEE board and the SPI cable, and replace them if necessary. The step axis controller is no longer initialized. This problem can be caused by a hardware fault, a power spike or a static discharge. ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:04 2008 PST